Now that I’ve gotten back on that horse, I’ve been going through a bit of a back log off issues.
Depending on the slicer l, which is code for I probably need to get back to defaults, I have either or both print height and adhesion issues. I thought I had previously dialed in Cura, but it’s currently starting all prints a free millimeters up. Slic3r is getting the print to stick, but it’s grinding through previously printed plastic after a couple layers.
I’ve tried some different settings, I’ve reduced the extrusion to make sure it’s to little z rather than too much e. I then did a full print, letting it grind away. I also tried turning off various parts, like the bed heater, to no avail. My next thought is slice like usual, and manually run each command. Maybe first I should do some test commands to measure what movement I get. I’ll have to start by heating the bed and extruder to make sure that I’m running legit.
I’ll try doing this tonight.