I got working on it a bit. After searching high and low for my glue gun, finally found it. Where I left it. I started having all the bottles end down, but realized I’d rather do the wiring even and the ends uneven. To do this, I grabbed two bottles of different heights, kinda attended then together and glued. From there it was just adding more bottles. I applied a line of glue and squished it in to place. A few of the bottles aren’t on hard, but they’re all good enough I can gently nice around the mass.
Now it’s wiring time. Unfortunately…
I can’t find my LEDs I’m using
My multimeter’s batteries are dead which means I can’t check to see if the I want to use is conductive
Well, I guess I could. Battery, resistor, LED and wire…